Press "Enter" to skip to content

The Secret of 300 135 tshoot pdf

Exam Code: ccnp tshoot 300 135 dumps (Practice Exam Latest Test Questions VCE PDF)
Exam Name: TSHOOT Troubleshooting and Maintaining Cisco IP Networks
Certification Provider: Cisco
Free Today! Guaranteed Training- Pass tshoot 300 135 pdf Exam.

2018 NEW RECOMMEND

Pass on Your First TRY 100% Money Back Guarantee Realistic Practice Exam Questions

Free Instant Download NEW 300-135 Exam Dumps (PDF & VCE):
Available on:
https://www.certshared.com/exam/300-135/

P.S. Precise 300-135 item pool are available on Google Drive, GET MORE: https://drive.google.com/open?id=1BNfdP-dYaYDxxYw2CbIPONm9qPz9JsvY

New Cisco 300-135 Exam Dumps Collection (Question 6 – Question 15)

Q6. You have the followings commands on your Cisco Router:

ip ftp username admin ip ftp password backup

You have been asked to switch from FTP to HTTP. Which two commands will you use to

replace the existing commands?

A. ip http username admin

B. ip http client username admin

C. ip http password backup

D. ip http client password backup

E. ip http server username admin

F. ip http server password backup

Answer: B,D

Explanation:

Configuring the HTTP Client

Perform this task to enable the HTTP client and configure optional client characteristics. The standard HTTP 1.1 client and the secure HTTP client are always enabled. No commands exist to disable the HTTP client. For information about configuring optional characteristics for the HTTPS client, see the HTTPS-HTTP Server and Client with SSL 3.0

, Release 12.2(15)T, feature module. SUMMARY STEPS

1. http://www.cisco.com/en/US/i/templates/blank.gifenable

2. http://www.cisco.com/en/US/i/templates/blank.gifconfigure terminal

3. http://www.cisco.com/en/US/i/templates/blank.gifip http client cache {ager interval minutes | memory {file file-size-limit | pool pool-size-limit}

4. http://www.cisco.com/en/US/i/templates/blank.gifip http client connection {forceclose | idle timeout seconds | retry count | timeout seconds}

5. http://www.cisco.com/en/US/i/templates/blank.gifip http client password password

6. http://www.cisco.com/en/US/i/templates/blank.gifip http client proxy-server proxy-name

proxy-port port-number

7. http://www.cisco.com/en/US/i/templates/blank.gifip http client response timeout seconds

8. http://www.cisco.com/en/US/i/templates/blank.gifip http client source-interface type number

9. http://www.cisco.com/en/US/i/templates/blank.gifip http client username username


Q7. The implementations group has been using the test bed to do a u2018proof-of-conceptu2019 that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, and FHRP services, a trouble ticket has been operated indicating that Client 1 cannot ping the 209.65.200.241 address.

Use the supported commands to Isolated the cause of this fault and answer the following questions.

On which device is the fault condition located?

A. R1

B. R2

C. R3

D. R4

E. DSW1

F. DSW2

G. ASW1

H. ASW2

Answer: G

Explanation:

Since the Clients are getting an APIPA we know that DHCP is not working. However, upon closer examination of the ASW1 configuration we can see that the problem is not with DHCP, but the fact that the trunks on the port channels are only allowing VLANs 1-9, when the clients belong to VLAN 10. VLAN 10 is not traversing the trunk on ASW1, so the problem is with the trunk configuration on ASW1.


Q8. Which of the following are byproducts of a structured maintenance plan? (Choose all that apply.)

A. Predictable security vulnerabilities

B. Economies of scale

C. Improved expenditure forecasts

D. Increased downtime

E. Predictable equipment obsolescence

F. Consumption of fewer resources

Answer: A,B,C,E,F


Q9. Which of the following are TACACS+ characteristics? (Choose all that apply.)

A. Cisco proprietary

B. Standards-based protocol

C. Provides separate services for authentication, authorization, and accounting

D. Encrypts only the password

E. Uses UDP for a transport layer

F. Encrypts the entire packet

Answer: A,C,F


Q10. The implementations group has been using the test bed to do a u2018proof-of-conceptu2019 that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

Use the supported commands to isolated the cause of this fault and answer the following questions.

The fault condition is related to which technology?

A. BGP

B. NTP

C. IP NAT

D. IPv4 OSPF Routing

E. IPv4 OSPF Redistribution

F. IPv6 OSPF Routing

G. IPv4 layer 3 security

Answer: G

Explanation:

On R1, we need to permit IP 209.65.200.222/30 under the access list.


Q11. The implementations group has been using the test bed to do a u2018proof-of-conceptu2019 that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

Use the supported commands to isolated the cause of this fault and answer the following questions.

On which device is the fault condition located?

A. R1

B. R2

C. R3

D. R4

E. DSW1

F. DSW2

G. ASW1

H. ASW2

Answer: A

Explanation:

On R1, for IPV4 authentication of OSPF the command is missing and required to configure-

—– ip ospf authentication message-digest


Q12. You examine the port statistics on a Cisco Catalyst switch and notice an excessive number of frames are being dropped. Which of the following are possible reasons for the drops?

A. Unknown destination MAC address

B. Bad cabling

C. MAC forwarding table is full

D. Port configured for half duplex

E. Port configured for full duplex

F. Network congestion

Answer: B,F


Q13. The implementations group has been using the test bed to do a u2018proof-of-conceptu2019 that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241.

After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

Use the supported commands to isolated the cause of this fault and answer the following questions.

Which is the solution to the fault condition?

A. Under the EIGRP process, delete the redistribute ospf 1 route-map OSPF_ to_ EIGRP command and enter the redistribute ospf 1 route-map OSPF – > EIGRP command.

B. Under the EIGRP process, delete the redistribute ospf 1 route-map OSPF_ to_ EIGRP command and enter the redistribute ospf 6 metric route-map OSPF – > EIGRP command.

C. Under the OSPF process, delete the redistribute eigrp10 subnets route-map EIGPR –

>OSPF command and enter the redistribute eigrp10 subnets route-map OSPF – > EIGRP command.

D. Under the OSPF process, delete the redistribute eigrp10 subnets route-map EIGPR –

>OSPF command and enter the redistribute eigrp10 subnets route-map EIGPR – > OSPF command.

E. Under the EIGRP process, delete the redistribute ospf 1 route-map OSPF _to_ EIGRP command and enter redistribute ospf 1 metric 100000 100 100 1 15000 route_ map OSPF

_to _EIGRP command

Answer: A

Explanation:

On R4, in the redistribution of EIGRP routing protocol, we need to change name of route- map to resolve the issue. It references route-map OSPF_to_EIGRP but the actual route map is called OSPF->EIGRP.


Q14. The implementation group has been using the test bed to do an IPv6 'proof-of- concept1. After several changes to the network addressing and routing schemes, a trouble ticket has been opened indicating that the loopback address on R1 (2026::111:1) is not able to ping the loopback address on DSW2 (2026::102:1).

The fault condition is related to which technology?

A. NTP

B. IP DHCP Server

C. IPv4 OSPF Routing

D. IPv4 EIGRP Routing

E. IPv4 Route Redistribution

F. IPv6 RIP Routing

G. IPv6 OSPF Routing

H. IPV4 and IPV6 Interoperability

I. IPv4 layer 3 security

Answer: G

Explanation:

As explained earlier, the problem is with route redistribution on R4 of not redistributing RIP routes into OSPF for IPV6.

Topic 21, Ticket 16: IPv6 Routing Issue 3

Topology Overview (Actual Troubleshooting lab design is for below network design)

u2711 Client Should have IP 10.2.1.3

u2711 EIGRP 100 is running between switch DSW1 & DSW2

u2711 OSPF (Process ID 1) is running between R1, R2, R3, R4

u2711 Network of OSPF is redistributed in EIGRP

u2711 BGP 65001 is configured on R1 with Webserver cloud AS 65002

u2711 HSRP is running between DSW1 & DSW2 Switches

The company has created the test bed shown in the layer 2 and layer 3 topology exhibits. This network consists of four routers, two layer 3 switches and two layer 2 switches.

In the IPv4 layer 3 topology, R1, R2, R3, and R4 are running OSPF with an OSPF process number 1.

DSW1, DSW2 and R4 are running EIGRP with an AS of 10. Redistribution is enabled where necessary.

R1 is running a BGP AS with a number of 65001. This AS has an eBGP connection to AS 65002 in the ISPu2019s network. Because the companyu2019s address space is in the private range. R1 is also providing NAT translations between the inside (10.1.0.0/16 & 10.2.0.0/16) networks and outside (209.65.0.0/24) network.

ASW1 and ASW2 are layer 2 switches.

NTP is enabled on all devices with 209.65.200.226 serving as the master clock source. The client workstations receive their IP address and default gateway via R4u2019s DHCP server.

The default gateway address of 10.2.1.254 is the IP address of HSRP group 10 which is

running on DSW1 and DSW2.

In the IPv6 layer 3 topology R1, R2, and R3 are running OSPFv3 with an OSPF process number 6.

DSW1, DSW2 and R4 are running RIPng process name RIP_ZONE.

The two IPv6 routing domains, OSPF 6 and RIPng are connected via GRE tunnel running over the underlying IPv4 OSPF domain. Redistrution is enabled where necessary.

Recently the implementation group has been using the test bed to do a u2018proof-of-conceptu2019 on several implementations. This involved changing the configuration on one or more of the devices. You will be presented with a series of trouble tickets related to issues introduced during these configurations.

Note: Although trouble tickets have many similar fault indications, each ticket has its own issue and solution.

Each ticket has 3 sub questions that need to be answered & topology remains same. Question-1 Fault is found on which device,

Question-2 Fault condition is related to,

Question-3 What exact problem is seen & what needs to be done for solution

=====================================================================


Q15. Which of the following statements regarding documentation would not be considered a helpful step in the troubleshooting process?

A. Use the Cisco Auto Configuration tool.

B. Use the Cisco Rollback feature.

C. Automate documentation.

D. Schedule documentation checks.

E. Use the Cisco Configuration Archive tool.

F. Require documentation prior to a ticket being closed out.

Answer: A


P.S. Easily pass 300-135 Exam with Dumpscollection Precise Dumps & pdf vce, Try Free: http://www.dumpscollection.net/dumps/300-135/ (129 New Questions)